Originally Posted by shawnp
Dead on, Dave. A few adjustments and corrected factors and that thing will be 1100+ in 2-3 pulls, even with an average dyno operator.
There is no other negative feedback on Naylor or proaction heads. There is positive feedback on proaction as a seller.
You can keep beating your dead horse here if you want, but until you decide that your done in a pissing match and would like to get help with your combo then don't expect a lot of replies. Your attitude toward those that can help you isn't going to get you far. :roll:
Any and all legitimate help/advice is appreciated. I don't think there will be any trouble in anyone seeing I have been cooperative and as courteous in replies to everyone.
I think this is obvious to everyone there are a few on here that likes to do nothing more than run their mouths and try to divert the attention from the matter at hand. The attitude shown toward me will be the attitude shown in return.
If the ones of you believe all the BS about the fuel system, the tune-up or the average dyno operator can get 1100hp out of my engine in 2-3 pulls by a legitimate shop, THEN PUT YOUR MONEY WHERE YOUR MOUTH IS!!!
At the start I offered the ones of you who were foolish enough to believe that your choice of 2 of the most reputable engine builders/dyno operators in the Southeast. All you have to do is pick the one of your choice & put your money where your mouth is!!