its all good beast i have asked about quite a few combinations i was just looking for hp estimates for some stuff i had "laying around" minus heads cam etc...
right now i have a mild sbc 350 stock bottom end 9.3:1 1.94 heads torker intake and 650dp.... 3200 stall 4.88's and m/t sportsmans right now... 350 hp aint bad but it aint enough
ive got a few blocks and sets of pistons and rings just trying to figure out what to spend the little money i have on just looking at all my options to upgrade but with the millage i get now the 5.3 or 6.0 should work great
but thanks for the help i appreciate it
not to worried about nos ive got a few good buddies that i trust with helping me tune for it... if it blows it blows it happens thats hot rodding and racing
dragonmaster if you would read i said i was looking at my options at the time i could have picked up a 454 2 bolt block for 50 bucks... just a kid trying to get the most bang for littlest buck... but my th350 and 8.5 10 bolt would have needed upgrading so im looking to go another route
- thanks logan