Here you go Keith,
Obviously the WD 40 didn't do the protection i expected it too do, i'll have to clean this pump before useing it again. I haven't even looked at it in over 2 yrs.
Note: the driven gear spindle is offset too the top of the pump. If you mount the pump with inlet and outlet vertical, the cam drive setup would put the driven gear off to the right, the belt drive setup would be opposite to the left 180*
Cover just as it came off of the pump, Note: the divider sets at the bottom of the pump, cover is flipped 180* from left to right.
Side view of cover as it came off the pump, this setup was ran on cam timing cover, NOT belt driven.
Hope this helps, this cover doesn't have a notch either but does have a small hash mark at the top of the cover.
Zip.