Originally Posted by DragsterJosh
I have a early 70's 350 block that has been bored .080 and a set of trw dome pistons that match it. My question is do you guys think this will be all right in a bracket car?
I am getting ready to build a new motor for my dragster and I have this sitting around, I was thinking about putting a 3.75 stroke crank in this and letting it rip.
What do you guys think???
Thanks Guys
I'm assuming that you want to get into something as cheap as possible and that's why you were looking at what you have. There's lot's of .060 over 350's running. I'm thinking the walls may be a little thin at .080 over, but with block filler it may be o'k. Before you spend the money on a 3 3/4" crank you need to check the pin height in those pistons you have, because it may require special length rods. other than that let it rip.
JMO
Zip.