Leaving tomorrow and headed for Gateway to run the NHRA open event.
I'll be running S/ST. Can't wait to dump the clutch :wink:
I thought it would never get here.
Just wanted to let you know how I did this week end at the track. I put a set of wheelie bars on for this year. What happen was I couldn't raise them up high enough. If I raised them up higher they would of bent the lower valance panel. I'm going to notch the lower valance panel for the bars to clear. What happen was the bars come down and lift the rear tires off the surface and spin the tires.
It's hard to dial the car in when it's spinning. I went out first round. I cut a
.050 light and ran a 11.00. The other guy cut a .034 and ran a 10.91. The car spun real hard and slowed down. No excuses though. I'll have it fixed next time out :wink:
[/img]