This was pulled as a running motor from the tube chassis car shown in the video. This was the motor in that car when the video was shot, summer of 2024. The motor is ready for reassembly as-is and has more life left in it at the current bore size.
Includes everything listed below:
-446 cubic inch RB Mopar, 77’ truck block.
-Block has been rigid stone honed to remove glaze, some light vertical cylinder scoring remains, from life as a race motor.
-Drilled and tapped for 1/2 inch Hemi internal oil pickup, if you'll be running in a car with a factory k-frame.
Internally balanced stock stroke steel crank (Crank has Heli-Coil repair of balancer bolt threads)
-Main bolts are factory Mopar.
-Viscous Crank Damper
-->.030 2295 Speed pro forged dome +12 cc pistons
-Compression ratio (.051 head gasket = 10.5:1) comes with 2 oversized bore Fel-Pros composite gaskets that are .051” compressed
-Compression ratio (If you buy .027 thick Cometic head gaskets = 11.1:1)
-Mopar LY Rods, press fit heavy duty pins, w ARP bolts
-Mopar Performance Stage IV iron heads, casting #3614476, ported and bowl blended, 2.14 Int/ 1.88 Exh valves, hardened seats.
-Head hardware ARP studs
-Comp springs set up for low .600” lift flat tappet cam
-Like new Cloyes 3 bolt +/- 4 degree timing chain and gear set
-Harland Sharp 1.5 ratio Rocker arms , hardened shafts, 3/8 heavy duty ball and cup push rods.
-Edlebrock Victor 440 intake manifold
-MSD distributor
-Keith Black oil pump, Milodon drag race pan with external lines and swinging pick up
-Holley 950 CFM race carb with velocity stack K&N air filter
-CSR electric water pump
-The motor had a Mopar performance 271 duration @ .050, .590” lift mechanical solid flat tappet cam. The cam had a lifter failure that flattened one lobe, so I pulled the cam.
To complete the build you will need to:
-Replace main and rod bearings
-Buy and install new piston rings
-Buy and install gaskets.
Install a new cam
Cam Options
-Run your own comparable flat tappet cam and run with the existing valve springs and push rods.
$$Optional: Add $1300 to purchase price
Convert motor to full roller:
I have a new in box comp cams solid mechanical roller cam that will require different valve springs and shorter length pushrods.
($350 for the new cam, $650 for the new Crower roller lifters, and $200 for the new Milodon Brass pump drive gear)
To complete the build you will need a cam:
Cam Options
-Run your own comparable flat tappet cam and run with the existing valve springs and push rods.
-Replace main and rod bearings
-New piston rings
-Gaskets.
$$Optional: Add $1200 to purchase price
Convert motor to full roller:
I have a new in box comp cams solid mechanical roller cam that will require different valve springs and shorter length pushrods.
($350 for the new cam, $650 for the new Crower roller lifters, and $200 for the new Milodon Brass pump drive gear)