Silverstone Gray, 153k miles, clean title in hand (currently not registered). Has some dings and scratches but not bad for track car. Set up and well sorted, reliable session after session, easy on consumables while remaining competitive.
Prepared for and currently runs in NASA TT5 class, has all current dyno and classification paperwork. Built by me for me with no corners cut. Not interested in parting out right now.
Drivetrain:
- 06 F22c1 w/ ~117k, 04-05 IM/TB/FI, strong stock engine, currently 207whp peak, detuned from 215 to meet class requirements
- Hondata K-Pro v4 ECU, custom tuned by Mikey from MSPEC in Chicago
- K&N intake
- HKS Hi-power cat back exhaust
- Mishimoto radiator
- Megan mounts
- A/C delete w/ OEM CR serpentine belt
- Air pump delete
- 06 transmission w/ clutch master PP, Comp clutch 11lb flywheel, and OE disk, TOB, pilot bearing. Same mileage as engine, clutch/flywheel have 1k miles
- 06 rear diff, same mileage as engine and transmission
Suspension/Brakes/Wheels:
- All suspension from an 06 front and rear: subframes, control arms, rear sway bar, knuckles, etc. 01 front sway bar
- Ohlins DFV coils, currently 12k/10k with swift springs up front, have a new set of 14k swift springs to make it 14k/12k
- Stoptech ST-40 front BBK w/ Raybestos ST-43 pads front and rear, 85% life left
- Rare “Evasive spec” bronze Volk Racing CE-28N wheels 17”x10” +44 all around w/ 255/40/17 NT-01
- Buddy Club front lower ball joints
- Prothane bushings all around
- Reinforced UCA mounting points
- All new alignment hardware
- Corner balanced and aligned
Interior:
- Mostly stripped except carpet, door panels, dash
- Custom welded in 4-point roll bar
- Authentic Bride Low Max driver and Recaro passenger seat on Planted mounts
- Schroth 6 point harnesses
- Personal steering wheel on NRG hub
- Fire extinguisher and cut off switch
Exterior:
- AP2 front and rear bumpers, taillights
- 06 head lights
- Mugen rep hard top
- Authentic ASM rear flares
- Racebred 3” chassis mount splitter
- 68” 9LR rear wing w/ 1/2” gurney and Baero CFD end plates
- Trackspec hood vents
- Fender vents, tire spats, winglets currently uninstalled due to not being legal for class but are included
- Trimmed rear bumper
- Spare tool well removed
Probably more that I’m forgetting and will come with the following extras:
- Sebring Silver OEM set of fenders
- Sebring Silver Passenger door with window and motor
- 2 x Sebring silver side mirrors
- 06+ ECU w/ key and ignition switch
- 06/07 Front Sway Bar
- 32mm Godspeed Front Sway Bar
- AC lines
- AP1 Front UCA (L + R)
- AP1 Front LCA (R)
- ABS sensor (R)
- Hand Brake handle with lines
- 06+ engine and interior wire harnesses
- Brake Pedal
- Soft top motors
- Rear Diff. Mounts with Prothane Bushings
- 06+ wiper/turn signal stalks
- 06+ Brake Booster
- 06+ Brake Master Cylinder
- JVC Head Unit
