This dyno both a large 42” 1700 lb inertia roller providing solid tire contact for grip and dual eddy brakes to hold in a specific range for detailed tuning. Low use and in very good condition.
Turnkey setup, still set up and ready for use or demonstration.
Includes everything needed for above ground operation, alternatively you can mount it in the ground:
- Dyno, Max measuring Power 2750 hp, Max Hold 1200 hp
- PC / PowerDyne Software
- Lift with attachment ramps
- Custom Stairs and walkway
- Support for Gas and Diesel by way of Inductive or optical pickup for RPM or use roller speed
- Simulation mode drag Christmas tree
- Center Strap pulls straight down for greater tire traction
- Power Curve Tests: Standard and precision sweeps with inertial and eddy current loading.
- Steady-State Testing: Holding constant speed or RPM targets for precise engine mapping and diagnostic work.
- Simulation Mode: Set percent load, incline or follow a pre-configured variable load
Requires 240 V 3 Phase for Dual Eddies with full 1200HP holding and 2750 HP measuring, Standard 240 Volt will run Single Eddy for 600 HP holding power with 2000+ HP measuring.
We aren't using it enough to justify the shop space.
Manual:
https://www.efianalytics.com/products/dyno/Imprtman.pdf
Specs:
https://www.efianalytics.com/products/dyno/MD-IMP_Specifications.pdf
Local Pickup only.
