(Comparison pictures are of the MM3 intake sitting next to an Edelbrock 2866 intake for visual size comparison.)
A DOMINATOR 4500 INTAKE FOR THE SB2.2....IT'S ABOUT TIME!!
Finally!!! An affordable alternative to expensive porting &
Dominator conversions on existing GM & Edelbrock SB2.2 intakes. The long awaited MM3 Single 4500 Spider Intake from M&M Competition Engines is here!
Although the MM3 single 4500 SB2.2 intake is inexpensive it does not sacrifice performance. In fact our cast manifold will outperform any & all existing cast spider intake manifolds with no additional porting & labor necessary! It was developed through our extensive porting programs that we have performed on the GM & Edelbrock spider intakes over the past several years.
Unlike the intakes that have been offered until now, there is NO NEED to EDM (cut) the intakes in ½, CNC port both halves, weld the intake back together, blend the weld, re-blast the intake, cut the top of the intake off, weld a 4500 Dominator plate to the intake, blend & blast that, and finally polish the inside of the intake. This labor is necessary to make the 048, 691, 617, 699 GM intakes work with the demands of today's high flowing SB2.2 heads on the big inch drag race engines.
Even with the extensive work that was mentioned above the GM & Edelbrock intakes are still too small & way too expensive once the labor is factored in!
That is where the MM3 intake comes into the picture. We have taken our best and brightest CNC programs from the past and enlarged them to enable the proper entrance angles, taper, runner radiuses, & cross section throughout the runner for the high HP producing SB2.2 engines of today. All of this is done within the existing casting. No longer do you have to spend weeks of time and thousands of dollars on an intake manifold still to have something that is the “crutch” of the engine. All you have to do is purchase the intake, port match it to your heads (WHICH WE WILL DO FOR NO ADDITIONAL CHARGE IF YOU SHIP US THE HEADS) & bolt it on!
Our MM3 Single Spider 4500 Dominator Intakes are innovatively designed to accommodate deck heights ranging from 8.800 to 9.625 & are available for all of the following:
- GM SB2.2 4.400 Bore Center
- GM ROX SB2.2 4.500 Bore Center
- Edelbrock SB2.2 4.400 Bore Center
- Edelbrock ROX SB2.2 4.500 Bore Center
This is the perfect accent to the complete SB2.2 Head Kits that we offer.
Tech advice available upon request or visit our website (which is under construction) @ www.mmcompetitionengines.com
BE SURE TO CHECK OUT OUR RACE SPACE AND VIEW OUR ALBUMS FOR MORE MMCE PRODUCTS!